holes in the fuselage frame were drilled through the main floor and
the aft floor, so I had to eyeball and drill all of them... done,
methed, and set.
Got the rudder cables run and attached to pedals and rudder... wow! a
working component! I was so impressed, that I ran the elevator cables
too! not fully installed, but done in the cockpit, which was a major
chore because I had to fit tiny washers on either side of the pully
wheels in order to get them to sit tight. Done.
More carbon in my fingers! now between each finger too!
1 comment:
Does the kit allow for a steerable tailwheel? The original one uses differential braking only, which definitely takes some getting used to...and makes having good brakes pretty critical!
Post a Comment